contact us

Use the form on the right to contact us.

You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right.

Hayes Way
Patchway, BS34

Aerospace Bristol is a new industrial heritage museum and learning centre being developed at Filton, to the north of Bristol. It will tell the story of the region's world-class aerospace industry - past, present and future. The Aerospace Bristol project is being run by the Bristol Aero Collection Trust.

Bolingbroke blog

Bolingbroke 9048 restoration progress

Martha Lewington

November 2018

We’re pleased to offer an update on the fantastic progress our Collections Team and Restoration Volunteers have made on the Bristol Bolingbroke.

It’s been around 3 months since we resumed work on the Bolingbroke, with our initial focus on the cockpit and tailplane. This is partly due to space constraints and partly to capture the knowledge of our volunteer team and make progress on the cockpit, which is probably the most complex part of the aircraft.


Inside the cockpit

Look carefully and you will see the refurbished rudder pedals have been trial fitted. You can see the new leather straps for the pilot’s feet.

Bolingbroke
 

Replacing the instrument panel

We are in the process of manufacturing a replacement instrument panel, as the original was severely damaged. We don’t have the drawings for this, so have used a mix of the original remnants and photographs. The black areas shown in the photograph are the remnants of the original instrument panel.

Bolingbroke

Bolingbroke

Repairing the tailplane

Repairing the tailplane structure in preparation to fitting the wingtip.

On the Tailplane we had an issue of significant damage to the structure and a missing wing tip.

The solution to the missing wingtip was to copy the one we had. Fortunately, they were designed to be fitted on either side so we could make an exact copy and know it would fit.


Riveting the new wingtip

One of the next tasks is to make a rear support structure for the Tailfin. This box section supports the rudder. And is a difficult component to make due to the thickness of the material and the number of interfaces with other aircraft parts at quite close tolerances.

Bolingbroke
Bolingbroke
Bolingbroke
Bolingbroke

Rudders and elevators

We are now turning our attention to the rudder and elevators. As you can see below, they are in need of a lot of TLC.

Bolingbroke
Bolingbroke

Thank you to all our restoration volunteers

We would like to say a huge thank you to all of the volunteers who are putting in so much hard work on the Bolingbroke restoration. The workshop is open for visitors to view whenever the volunteers are working and it has already proven very popular with visitors.

Of course, we will keep you updated as work progresses.